求助! 廠里進口拉絲機設備配電柜里面 PILZ的安全模塊 型號PNOZ  mm0p   772000損壞里面有程序嗎？有用過的師傅嗎？我第一次搞著東西廠里的損壞了不知道買個新的能不能用，是否有程序？請各位指教？謝謝了

不用重新編程，把chip card從壞的里面拿出來，插到新的里面就可以了。

Load project from chip card
Procedure:
1. Insert the chip card containing the current project into the card slot on the base unit.
2.Switch on the supply voltage. The LC display shows the project name, CRC sum and
   the date the project was created. Please check this information.
3.Load the project by pressing the rotary knob. For the project to be downloaded, the
   rotary knob must be held down for between 3 and 8 seconds. Once the project has
   been successfully downloaded, the status of the inputs and outputs will be shown on
  the display.

但是真好用。